Sunday, 16 December 2012

No Sew Toad Stool Pin Cushion Tutorial

Hello my crafting friends, I've been a busy bee again.......
I love the satisfaction of creation something out of what some people would call trash don't you? Well today I've made a cute pincushion/storage jar out of two yogurt pots and a jam jar! how cool is that? If you fancy having a go just follow my tutorial it's easy-peasy-lemon-squeezy!
You will need........

  • Two mushroom shaped yogurt pots (mine are Muller)
  • Glass jar small enough to fit inside your pot
  • Brown acrylic paint
  • Red and white spotty cotton (big enough to cover your pot)
  • Wadding - I used 3 layers of light weight wadding
  • Rubber bands
  • Bull-dog clips
  • PVA glue 
  • Ribbon to wrap around the bottom of your pot
  • White wool felt to wrap around your jar
  • Hot melt glue gun (optional)
1. The first instruction I have no photo for because... well..... because I forgot :). simply paint the inside of one pot with brown acrylic paint and put aside to dry (it will need two coats of paint).
2. cover the second pot with PVA glue.
3. Cover with wadding and secure with a rubber band.
4. Trim the wadding.
5. Brush with glue and repeat with the next two layers of wadding.
6. ......until it looks like this. Trim again.
7. cover with spotty cotton, secure with rubber band and tweak until you are happy with the position of the gathering. Trim off excess fabric leaving about one inch to fold underneath.
8. Spread glue around the inner rim of the pot.
9. Fold the red cotton inside the pot and secure until dry with bull-dog clips.
10. Now measure a strip of white felt deep enough to reach the lower rim of your jar and long enough to wrap around it.
11. Here's mine.
12. Cover the jar in glue.
13.Attach the felt and secure temporarily with a rubber band (who knew rubber bands could be so handy!)
14.When the glue is dry and after removing the rubber band finish of with some fancy ribbon. Now back to the lid.....
15. Now take the first pot (which you painted brown inside). Cover with a thin layer of glue and allow it to get a little tacky. Now slot it inside your padded pot - securing the red fabric in place.
16. Glue the space which shows between the two pots and attach your ribbon.

It should look like this. At this point you could say your toadstool is finished and simply pop the top onto the jar but I prefer to attach the lid of the jam jar to the inside of the yogurt pot (using a glue gun) so that the toadstool top screws on and off the base in one go.
After gluing put the padded top on before the hot glue sets.

Voila! there you have it!
I hope you enjoyed my tutorial. As far as I am aware this is my own idea and I haven't seen it anywhere else (who knows!) so please give me credit for the design if you do happen to recreate it. Thank you for your visit. I would love to see yours if you make one so please send me a link.
Happy crafting.

Saturday, 8 December 2012

My Craft Room - Time for a Nosey

Hi all,
I promised you a nosey of my new craft room ages ago - I hope you weren't all holding your breath in anticipation :/. I have taken lots of Photos today, as you will see I get a lot of daylight in this loft room so some of the pictures are a little over exposed but I will never complain about too much daylight!
I had a bit of a tidy up bit it is not pristine, I am a proper crafter so expect some smudges  and general untidiness. I hope my craft area inspires you!.......
 Here is a main view of where the magic happens. I have a long room so I'll give you it in little bits. The wall shelving unit was made by me and my lovely dad (thank God for dads!) The bottom shelve is a boxed-in shelf which contains the wiring for my under shelf lighting (which I wired myself!), this is were my best plan came into action!........
 I had been looking around at storage ideas for my Copic markers for some time and I had a few ideas in my mind... but then......along came my Copic sized shelf and the light bulb above my clever little head pinged! I'm a big fan of using magnets wherever possible so that's the route I took.I covered the shelf front with trimmed down A4 magnetic sheets then covered them with white sticky backed plastic so when the pens are removed I have a normal looking white shelf. After some trial and error I managed to get some magnets that were good and strong to attach to my pens - I just attached them with sticky tape....

 I love my Copic shelf, it looks great but most of all the pens are all nice and handy and at arms reach.
Here's part of the shelf to show how it looks with nothing on. now take a look at another way to use the shelf....
I attached an adhesive magnetic strip under the shelf so I can hang my little bottles of perfect pearls underneath - upside down and ready for squeezing!
here I have my lovely new tv/monitor which my lovely man bought me for my birthday. This is where I sit and design my digi images for Charmed Cards and Crafts.
Here's a little bit of ribbon storage at the other end of the shelf...
Oooh and here's my Prisma pencil stand - again made by my wonderful dad!
Lets move on to these amazing magnetic spice racks, they were form Argos and they were a special treat to myself, aren't they ace!
Lets move on to my 12"x12" paper storage......
It's shoe storage! I can't remember for sure but it was from either Ikea or Argos.
It's the perfect size for scrapbook paper. Here are a couple more magnetic boards one is for my metal dies. perfect!

 This magazine rack is from Ikea, I haven't got around to filling it yet but its handy don't you think?

The other end of the room has my main storage (this used to be my daughter's bedroom) these wardrobes hold loads! Fitted by my wonderful partner - I love you Souleymana mmmmwahhh!Oops, I nearly forgot to show you my storage rails.....

Another Ikea best seller!
What do you think? I hope my craft room inspires you to make better use of you crafty space. I'd love to have some feedback. Thank you for visiting xxx